[TR] Upgrading to a wood dash

tom white tswhitez123 at hotmail.com
Thu Dec 31 08:37:12 MST 2009


Another method to avoid splitting the venier when drilling is to tape over the
area before drilling.

Best regards,
Tom



> Date: Wed, 30 Dec 2009 21:44:47 -0500
> To: triumphs at autox.team.net
> From: fishplate at charter.net
> Subject: Re: [TR] Upgrading to a wood dash
>
> At 07:55 PM 12/30/2009, Brian Jones wrote:
>
> >I hope your dash comes with the screw mounting holes pre-drilled. Mine did
> >not. It is not a simple process to drill it yourself. You have no room for
> >error and the wood, when held in place, conceals the locations for the
> >screws and there is very limited access to the back of the upper screw
> >holes.
>
> I don't know exactly how this works, but can you put the screw
> through the metal dash backwards so it pokes out just a little, then
> align the wood dash and press it down?  That should make some dimples
> on the back of the wood dash that you can use to drill through to the
> front.  Be careful not to split the veneer when the drill comes
> through...press the dash down on a scrap piece of wood before you drill,
maybe.
>
> _______________________________________________
>
> Support Team.Net  http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
> You are subscribed as tswhitez123 at hotmail.com
>
> Triumphs at autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
>
> http://www.team.net/archive

_________________________________________________________________
Hotmail: Trusted email with powerful SPAM protection.
http://clk.atdmt.com/GBL/go/177141665/direct/01/


More information about the Triumphs mailing list