[TR] low profile aluminum jack

tom white tswhitez123 at hotmail.com
Sat Dec 26 09:31:02 MST 2009


I guess depending on the brand you can buy a seal kit for the jack.  I'd bet
Summit has them.  Resealing the hydraulic cylinder is not very difficult.

Best regards,
Tom



> From: sumton at sbcglobal.net
> To: triumphs at autox.team.net; 6pack at autox.team.net
> Date: Fri, 25 Dec 2009 21:29:03 -0600
> Subject: [TR] low profile aluminum jack
>
> hi, all.  hope your holidays have been restful.
>
> I am apparently to be the recipient of a new aluminum low profile hydraulic
> jack, and I want to know which is recommended?
>
> I had a summit racing jack which I loved, but the seals are shot after only
> a few years.  is there a place that fixes these?  should I replace it?
>
> thanks in advance!
>
> _______________________________________________
>
> Support Team.Net  http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
> You are subscribed as tswhitez123 at hotmail.com
>
> Triumphs at autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
>
> http://www.team.net/archive

_________________________________________________________________
Hotmail: Free, trusted and rich email service.
http://clk.atdmt.com/GBL/go/171222984/direct/01/


More information about the Triumphs mailing list