[TR] TR4/Webers - that banging noise- #2

[Lee&John Howard]

Excellent idea, Tom. I'll do that and report back.
John

On Sat, Aug 8, 2009 at 8:19 AM, tom white <tswhitez123 at hotmail.com> wrote:

>  You say the rod bearing was in place and torqued properly.  To be certain
> the bearing is OK you need to measure the clearances with a micrometer.
> Measure the rod journal and note the diameter.  Then place the rod bearing
> in the rod cap and torque the cap while the rod is off of the crank.  Then
> measure th inside diameter of the bearing.  Subtract the journal diameter
> fromt the bearing diameter to get the amount of clearance.  Compare your
> answer to book specs.
>
> Best regards, Tom
>
>
>
>
> ------------------------------
> Windows Live: Keep your life in sync. Check it
out.<http://windowslive.com/explore?ocid=PID23384::T:WLMTAGL:ON:WL:en-US:NF_B
R_sync:082009>