[TR] Help Needed With TR4A Hood Latch
dlylis at gmail.com
dlylis at gmail.com
Mon Aug 3 11:14:35 MDT 2009
Been there with my TR6. Drive over a speed bump.
------Original Message------
From: GHaynesTR4 at aol.com
Sender: triumphs-bounces at autox.team.net
To: triumphs at autox.team.net
Subject: [TR] Help Needed With TR4A Hood Latch
Sent: Aug 3, 2009 12:18 PM
Here's the sad scenerio:
We're installing the hood on my TR4A following a new paint job.
While adjusting the front hinges, we allowed the hood to latch (at the
back).
Now the latch will not release.
THE RELEASE LEVER IS RETRACTED FULLY (both from inside the car and using
the emergency cable.)
We removed the hinge bolts by reaching up from below, so the front now
opens maybe 3 inches.
With a stick and a hook, we were able to poke the latch and pull on it.
No luck releasing it!
Short of torching a large hole in the rear of the (freshly-painted) hood,
does anyone have a suggestion for releasing the latch pin, which may have
sunk too deeply into the latch?
George Haynes
_______________________________________________
Support Team.Net http://www.team.net/donate.html
This list supported in part by the Vintage Triumph Register
http://www.vtr.org
Triumphs at autox.team.net
http://autox.team.net/mailman/listinfo/triumphs
You are subscribed as dlylis at gmail.com
http://www.team.net/archive
Sent via BlackBerry by AT&T
More information about the Triumphs
mailing list