[TR] Brake master cylinder

[Bob Danielson]

I never even heard of bench bleeding until this post.......but that doesn't
mean much. I replaced my M/C in '07 and had it off the car again this past
winter. Obviously I didn't bench bleed it either time and the brakes are
nice and firm and I had no problem bleeding them either time.

Bob Danielson
1975 TR6 CF38503U
Running w/ Throttle Body Injection
Toyota 5 Speed & Nissan LSD
http://tr6.danielsonfamily.org 

-----Original Message-----
From: triumphs-bounces at autox.team.net
[mailto:triumphs-bounces at autox.team.net] On Behalf Of Randall
Sent: Friday, October 24, 2008 10:39 AM
To: triumphs at autox.team.net
Subject: Re: [TR] Brake master cylinder

> However, when you are installing an
> new master cylinder bench bleeding is the only way to get all the air 
> out of it.

Well, just to present the opposing viewpoint, I have never bench bled, and
it's never caused me any problems.  I rebuilt both MCs on TS13571L just the
other day; both pedals are high and firm after just ordinary bleeding of the
brakes and my usual "pump and hold" technique on the clutch.

This car was "put away wet" over 30 years ago; what I found in every single
aluminum hydraulic cylinder would make a poster for why I hate glycol fluid.
Not just seized, but full of hard, crunchy yellow stuff that I literally had
to chip away.

Randall
This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs at autox.team.net
http://autox.team.net/mailman/listinfo/triumphs

You are subscribed as 75tr6 at tr6.danielsonfamily.org

http://www.team.net/archive