[TR] clutch MC will not come apart

[Lee&John Howard]

I just this week had the same problem. I soaked it repeatedly in PB Blaster,
left it overnight, slammed it straight down until the piston finally came
flush to the end. Then a diagonal tapping dislodged it. I also had to clean
a lot of crud out of the bore. If it is frozen, first tap it further in to
break the gunk seal.
John

On Wed, Mar 12, 2008 at 7:03 PM, <DLylis at aol.com> wrote:

> With the bore facing downward slam it very hard at an angle onto a wooden
> surface.  I use my workbench.
>
> David  Lylis
> 69 TR6 CC26160L
> 60 TR3A TS74461LO
>
>
>
> **************It's Tax Time! Get tips, forms, and advice on AOL Money &
> Finance.      (http://money.aol.com/tax?NCID=aolprf00030000000001)
> _______________________________________________
>
> Support Team.Net  http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
>
> Triumphs at autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
> You are subscribed as leejohn7 at gmail.com
>
> http://www.team.net/archive