[TR] TR6 tranny alignment - use of dowels

[Randall]

> It is very  
> important that you know the clutch spline has been properly 
> engaged by the input  
> shaft before much torque is put on these bolts.

Another point that may or may not be helpful : I found the plastic alignment
tool to be nearly worthless, because it was too loose a fit in both the
clutch plate and the pilot bearing.  I can do just as good a job by feeling
with my fingers.  A spare (ruined) input shaft makes a much better alignment
tool, IMO.

Personally, I don't use nuts/bolts to draw the gearbox up at all.  Just
wiggle it around until it slides into place. 

Randall