[TR] Weber DCOE fuel inlet parts

Mike Denman mikedenman at sbcglobal.net
Mon Feb 25 12:15:07 MST 2008


There are probably lots of places you could get these washers but Pierce 
Manifold in Gilroy California will have them... 
http://www.piercemanifolds.com. They are the largest distributor of Weber 
carburetors in the USA. NFI etc.
Mike Denman

----- Original Message ----- 
From: "Chuck Arnold" <triosan at gmail.com>
To: "Friends" <fot at autox.team.net>; "Triumph" <6pack at autox.team.net>; 
"Triumph Email List" <triumphs at autox.team.net>
Sent: Monday, February 25, 2008 10:45 AM
Subject: [TR] Weber DCOE fuel inlet parts


>I have a set of triple Weber DCOEs.  The fiber/cotton?? washers surrounding
> the banjo bolts on the fuel inlets have deteriorated to the point they
> leak.  I cannot find replacement parts.  The outer one is 15mm, but crush
> washers come only in14 [too small] and 16 [too big].  The Carb supplier I
> usually use says they are not available.  Does any one have a source?
>
> -- 
> Chuck Arnold
> _______________________________________________
>
> Support Team.Net  http://www.team.net/donate.html
>
> This list supported in part by the Vintage Triumph Register
> http://www.vtr.org
>
>
> Triumphs at autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs
>
> You are subscribed as mikedenman at sbcglobal.net
>
> http://www.team.net/archive 


More information about the Triumphs mailing list