[TR] Scuttle vent rod connector

[wbeech]

 Or try your local motorcycle shop as these are used to make cable ends when
that can't be soldered.

Bill B
'58 TR-3A TS/30766 L
The car is in a 'zillion' pieces... but I think about it every day!


-----Original Message-----
From: triumphs-bounces+wbeech=flash.net at autox.team.net
[mailto:triumphs-bounces+wbeech=flash.net at autox.team.net] On Behalf Of Bob
Labuz
Sent: Monday, February 18, 2008 4:13 PM
To: 308gtsi at adelphia.net; Triumph Email List
Subject: Re: [TR] Scuttle vent rod connector

On Monday 18 February 2008 04:53 pm, Brian Induni wrote:
> Thanks Bob, but I have the rod. What I need is the small, obscure 
> connector to attach the rod to the lever under the dash. I image it 
> looks something like a cable stop, but I'm not sure.
>
> Brian
>
Brian,

Sorry, mis read your post.

Yeah I didnt have that little gizmo either so I made one out of a similar
part that is in the heater water control.

Take a look at Moss part # 473-070.

I had a few of these lying around and it fit just fine after I drilled out
the cable hole a bit.

The parts manual lists this part as 612219. TRF says they have it.

about 2 bucks.

Sorry for the error post!

Bob
This list supported in part by the Vintage Triumph Register
http://www.vtr.org


Triumphs at autox.team.net
http://autox.team.net/mailman/listinfo/triumphs

You are subscribed as wbeech at flash.net

http://www.team.net/archive