[TR] Lift in my Garage

[Kentech HomeTech]

I also use a line of tape to get my 3A on the 4-post BendPak; The inside
edges of the tires are just barely on the tracks. A great outfit (nfi) has
been http://www.asedeals.com/garage_lift.html. I purchased the BendPak there
also a low profile AC Hydraulic jack. No problems with either and both are
on my top 5 shop tools. 
PeterK

-----Original Message-----
From: Chris Simonsen [mailto:ccsimonsen at gmail.com] 
Sent: Saturday, September 22, 2007 1:49 PM
To: Mike Denman
Cc: Triumphs list
Subject: Re: [TR] Lift in my Garage

The tape is a good idea.  I ended up moving one side of the track over 16
inches to make sure I did not fall in the hole!

Been so busy - I use mine more or storage than anythign else - does come in
handy for filling the diff and tranny.

Chris

63 tr4
54 tr2


On 9/22/07, Mike Denman <mikedenman at sbcglobal.net> wrote:
>
> I have the Eagle Brand lift and it works fine but I wouldn't buy 
> another lift from them. As recieved, the safety locks were defective 
> and one of the cables that does the lifting was too long. You have to 
> be careful with the British cars because of their narrow track. In 
> spite of the narrow track and the wide spacing of the lift rails, I 
> use the lift for my TR3, Marcos and TVR... you just have to be 
> careful. I have put tape the full length of the lift rails 
> corresponding to the colors of the cars involved and I make sure that 
> I drive straight on the lift with the driver's side front tire on the 
> correct colored tape.
> Mike Denman
>
> ----- Original Message -----
> From: "THOMAS FANSHER" <tfansher at comcast.net>
> To: "Triumphs list" <triumphs at autox.team.net>
> Sent: Saturday, September 22, 2007 10:00 AM
> Subject: Re: [TR] Lift in my Garage
>
>
> > I've got a two post Mohawk lift that I love. It's got 3. inch 
> > clearance, which is the lowest in the industry. I got the 10,000 
> > pound one which is WAY overkill for the Triumphs, but not so much 
> > for the GMC 2500HD truck.
> > I did a fair amount of research and am happy that I bought the made 
> > in
> USA
> > unit.  It needs 12.5 feet of height for clearance - less if you run 
> > the pipes on the floor.
> > Tom
> > _______________________________________________
> > mikedenman at sbcglobal.net
> >
> > This list supported in part by the Vintage Triumph Register 
> > http://www.vtr.org
> >
> > Triumphs mailing list
> > Triumphs at autox.team.net
> > http://autox.team.net/mailman/listinfo/triumphs
> _______________________________________________
> ccsimonsen at gmail.com
>
> This list supported in part by the Vintage Triumph Register 
> http://www.vtr.org
>
> Triumphs mailing list
> Triumphs at autox.team.net
> http://autox.team.net/mailman/listinfo/triumphs