[TR] [6pack] Hood Buldge

[N197TR4 at cs.com]

Hi Al,

If I were to do it, I would cut out the horizontal shape of power bulge in 
the TR6 hood.

Then cut out the power bulge from the TR4 hood, leaving a small margin around 
the edge.

Then I would fit the power bulge from underneath and secure it with tack 
welds.

Then go from there..........

Joe A


> I have seen some TR6's with a TR4 power scoop or hood buldge grafted on.
> I was wondering how this was accomplished.
> Did they take a TR250 hood and cut off the end and attach the TR6  end.
> Or did the cut out the power scoop and spot weld it to the TR6 hood and 
> feather it in.
> I had met the fellow that was doing it at a TRF summer party years ago. But 
> I wasn't paying attention as to how it was done.;
> just thought it looked pretty neat.
> Since I could see the indentation of the buldge from the underneath, I don't 
> believe it was spot welded.
> 
> Any ideas?
> 
> Al Salvatore
> polished intakes is the game
> www.triumphowners.com/624 
> 

   </HTML>