[TR] TR4 handbrake grommet / gearbox cover question

[J.C. Hassall]

Listers,

I have a fiberglass gearbox tunnel (which doesn't fit worth a damn) 
which doesn't seem to seal properly.  The PO replaced the pax side floor 
board but it didn't have a cutout for the handbrake.  I cut a hole in 
the floor, but something doesn't seem right.  The gbx cover has a flat 
area into which the h'brake grommet is apparently intended to fit. 
However, if I cut the gbx cover, it'll leave an open area for water, etc 
to pool on the floorboard inside the grommet.  And that makes no sense. 
  WTF, over?

TIA

jim
-- 
J.C. Hassall
Blacksburg  VA
64 TR4 in autox preparation
95% finished, 90% to go