<div dir="ltr"><div class="gmail_default" style="font-size:small">I'm installing some new rubber on the factory hard top for my series 5 Tiger.  The new corner pads  (from SS)  seem to be exact reproductions of the ones I removed (also probably SS from decades back), position of the screw holes, everything..  But I noticed that if I let the pads sit in a position where the flat bottom of the pads sit fully against the hard top frame, the screw holes do not line up with the screw holes in the frame.  They are about half an inch further forward.  If I line up the holes, with the pad maybe half an inch toward the rear, the rear of the pad isn't fully seated, and the hardtop would sit a little higher when mounted on the body.  Looking carefully at the removed pads, I see the same thing, which might explain why I always had a problem getting those pointy things on the rear of the top to align with the holes in the trunk hinges.</div><div class="gmail_default" style="font-size:small"><br></div><div class="gmail_default" style="font-size:small">I am tempted to redrill the hardtop frame holes to line up with the pad holes, with the pad in what seems to be it's natural position.  Has anyone else seen or solved this?</div><div class="gmail_default" style="font-size:small"><br></div><div class="gmail_default" style="font-size:small">Stu Brennan</div></div>