<div dir="ltr">Me again,<div><br></div><div>I'm starting up my engine now and it seems to run fine but only if I keep the RPMs up above 2000.  I have an Edelbrock AVS2 500CFM carb on an otherwise stock engine.  I have the distributor vacuum  advance plugged into the metered vac port on the carb and all other vac ports are plugged.  The is a manual choke carb and I have the choke closed when I start the engine.  After running the engine for a few minutes if I try to open the choke the engine dies.</div><div><br></div><div>So, I'm looking for ideas.  How long do I need to let the engine run before opening the choke?  Is the timing causing the need to run at high RPMs?  I haven't tried to adjust the timing yet.</div><div><br></div><div>Thanks,</div><div>Joe Brown</div></div>