[Tigers] tiger rear end

[Gary M. Gere]

If memory serves, when the differential itself has 7/16 inch threads and the ring gear is machined with 1/2 inch diameter holes there are two options:

Use a stepped ring gear bolt that has a grip (unthreaded portion of the shank) of 1/2 inch with 7/16 thread such as ARP 350-3004

Use a bolt that is fully 7/16 inch in which case 1/2 to 7/16 ring gear bolt sleeves are used such as Yukon gear YSPBLT-028.

Neither is needed if both the ring gear and differential are machined/threaded for the same diameter.

-Gary

> On Mar 23, 2023, at 5:50 PM, Clyde Mclaughlin via Tigers <tigers at autox.team.net> wrote:
> 
> 
> I have seen the stepped bolts for the ring gear, I believe you need them for any newer gear sets, just did one for and E type and it came with the bolts. the LSD unit in that e type was the same as a tiger one I have.
> _______________________________________________
> 
> tigers at autox.team.net
> 
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/tigers http://autox.team.net/archive
> 
> Unsubscribe: http://autox.team.net/mailman/options/tigers/ggere@comcast.net
> 
>