[Tigers] Clutch issue
Jerry Christopherson
JCMC2006 at suddenlink.net
Fri May 28 15:49:36 MDT 2021
Well, I did some measuring today (by the way the new clutch and cylinder
kits didn't solve my problem) and thought I would pass on info for anybody
that is interested.
The actual amount of movement of the slave cylinder with a full to the floor
movement of the clutch peddle is .745". The measure of the piston movement
from the very back to when the piston comes to the very front of the
cylinder (not protruding) is like I mentioned before is 1.35", so that
leaves approximately .605" more potential movement to apply to the clutch
arm. I'm hoping the .700 Girling master cylinder I just ordered will take
up just that amount. I can only hope. HA! If not I'll pull the engine and
tranny again and get a CF clutch. As for a annular TO bearing, my friend
has a highly modified Mazda with a 331 Ford engine for road racing with a
annular TO bearing and it works very well with the stock master cylinder. I
would be very interested in why TH doesn't like them anymore.
Jerry
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/tigers/attachments/20210528/94102e0e/attachment.htm>
More information about the Tigers
mailing list