[Tigers] Windshield lower trim strip

[Gary Winblad]

Stu,
Yes, just give up and take it off, you know how to do it!
It will be easier next time (you already solved the tilt and hole 
cutting problems I assume)
You might just have to loosen it and lift it up a little?   I have done 
at least two windshields over the years and I can't
remember how I did it but at least after a while you forget what a pain 
it was  :)
Gary


On 9/6/2019 6:43 AM, Stu via Tigers wrote:
> As I told Joe a few days ago, I'm struggling with the lower SS trim 
> strip on the windshield frame.  The frame is now installed on the car 
> with all new gaskets.  The lower strip is the last trim piece to go 
> on.  I've tried all the combinations, getting the top of the ss strip 
> in first, the bottom in first, and trying to get both top and bottom 
> in together as I go side to side.  No success either way.
>
> I think one of the on line videos showed that the guy had put the 
> bottom strip in last with the frame on the car, but it didn't show how 
> he did it.
>
> Anybody out there have any success at this?  Or should I just give up, 
> remove the windshield again, install the SS strip, then put it back?
>
> Stu
>
> _______________________________________________
>
> tigers at autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/tigers http://autox.team.net/archive
>
> Unsubscribe: http://autox.team.net/mailman/options/tigers/garywinblad@comcast.net
>
>