[Tigers] Windshield frame mounting studs

[Tom Parker]

Because I don't contort well in my advanced age I just bite the bullet and
pull the dash. A reminder if you don't have them, Rick (SS) sells Tom
Hall's windshield adjusters. PN WS58 on page 20 of the 2016 catalog.. Note:
you'll have to grind down the exterior of a 1/4" drive 3/8" deep well
socket to fit the Tiger's frame holes...

Tom, '67 Mark 2

On Sat, Mar 2, 2019 at 1:05 PM Stu via Tigers <tigers at autox.team.net> wrote:

> So I tried to check the last detail before ordering all the stuff for the
> windshield gasket project.  I can see most of the nuts on the studs under
> the dash, but the videos I found on Youtube show there another stud right
> at the center, that must be somewhere above the heater fan. I tried to get
> a look at it by sticking my cell phone camera up there, trying to look over
> the fan assembly, but no luck there.
>
> So it looks like the fan assy will have to come out.  Right?  Or is there
> a trick?
>
> Stu
> _______________________________________________
>
> tigers at autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/pipermail/tigers
> http://autox.team.net/archive
>
> Unsubscribe:
> http://autox.team.net/mailman/options/tigers/tkparker1941@gmail.com
>
>
>
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/tigers/attachments/20190302/c68c28b5/attachment.html>