[Tigers] top loader 4 speed wide ratio

[coolvt at aol.com]

The repair manuals have instructions for adjusting the linkage.  Did you  follow the manual  so that you  are sure it's adjusted correctly?
In a message dated 4/19/2019 2:14:52 PM Eastern Standard Time, tigers at autox.team.net writes:

After  my recent engine rebuild  I am having trouble with the tranny getting stuck in two gears.  Not good.  It occurs when trying to go forward after putting it in reverse It won't go into any forward gear. Did I perhaps bend something getting it back into the tunnel on replacing the motor?  I didn't do anything to the tranny  when out of the car.  I did clean it up and repaint before re-entry.  It was suggested that  I cleaned it too good and it needed to be relubed on the rods and levers.  That did seem to help but it still gets stuck on occasion and I can release it by putting it back into reverse.  That is the good news. I had to get under the car and hit the lever before to pop it out of gear.    The levers all line up where they should be under the shifter.  Fluid level is good.  Is the fluid correct( valvoline gear oil--high performance 80-90w )?  Any suggestions would be appreciated.  Russ                 rtscolgan at yahoo.com_______________________________________________

tigers at autox.team.net

Donate: http://www.team.net/donate.html
Archive: http://www.team.net/pipermail/tigers http://autox.team.net/archive

Unsubscribe: http://autox.team.net/mailman/options/tigers/coolvt@aol.com



-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/tigers/attachments/20190419/4108cbf3/attachment.html>