[Tigers] Transmission's Speedometer Gear Clamp

[e.coiner e.coiner]

It is either 1/4-20 or 5/15-18.  The key to access is removing the little sheet metal panel on the side of the tranny hump.

Lift the carpet on the drivers side of the hump near the shifter. You will see the panel.  5 or so phillips screws later and you can see the trans cable and bolt.  It still ain't easy but it can be done.


Erich

> On September 19, 2018 at 4:38 PM Rob Hogan via Tigers <tigers at autox.team.net> wrote:
> 
>     Anyone know what bolt diameter and thread pitch is used to bolt the speedometer gear clamp on to the side of the transmission?  It has been 35 years since it was last disassembled and 42 years since I last assembled it and I don't know what is needed anymore.  Accessing that bolt's hole is going to be a challenge.
>     _______________________________________________
> 
>     tigers at autox.team.net
> 
>     Donate: http://www.team.net/donate.html
>     Archive: http://www.team.net/pipermail/tigers
> 
>     Unsubscribe: http://autox.team.net/mailman/options/tigers/e.coiner@cox.net
> 
> 
> 
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/tigers/attachments/20180919/cf6753ec/attachment.html>