[Tigers] Fwd: Clutch fork.... Still....

[genepadgett at comcast.net]

Sorry, meant to reply to all. 

Gene 

----- Original Message -----
From: genepadgett at comcast.net 
To: johnp at ciseast.com 
Sent: Tuesday, March 5, 2013 3:31:42 PM 
Subject: Re: [Tigers] Clutch fork.... Still.... 


Hi John, 

Here are the dimensions of the fork from my Mark IA with stock close ratio trans. All dimensions in inches. 

L=10.5 
IN=1.7 
CC=2.4 
SE-4.5 
SD=5.0 
SP=DNK 
The ID of the throwout bearing is 1.445. My new one is Centerforce PN2439. My old one (not oem by now!) measures about 1.440. 

The extended tip by the dimple on the end is squared off rather than rounded like your overlay drawing on your pic. 

I trust you have the fulcrum retaining spring/clip as well as the clip that holds the slave cylinder rod end in the dimple. I have a source for the fulcrum clip if you need it. 

Let me know if you need any other info. 

Gene 
----- Original Message -----