[Tigers] Where to find parts, shifter...

[Ron Fraser]

Chip
	Never believe the temp gage until you check it with your infrared
thermometer or by other means.  My temp gage reads a little low and I know
others that read a bit high.  Once you know what the temp is you can have
some peace of mind.  You either live with the gage or you look at
calibrating the temp gage.

Ron Fraser

-----Original Message-----
From: tigers-bounces at autox.team.net [mailto:tigers-bounces at autox.team.net]
On Behalf Of Chip Broadbooks
Sent: Sunday, June 16, 2013 9:20 PM
To: undisclosed-recipients:
Cc: tigers at autox.team.net
Subject: Re: [Tigers] Where to find parts, shifter...


I just dropped  a 14" Flex-A-Light off last week at a machine shop to get
the 1" pilot hole. They told me they would hone it out to 1". I, personally,
thought I could do it myself with a drill. I wasn't too far off on my
effort. About 1/8". I remember all of the forces of a rotating mass from my
engineering classes and tossed that fan, bought another, and am paying the
money. All I need is to destroy the bearings in the water pump and
potentially crack my timing cover. I know the mass wasn't that great, but I
am not taking the chance.

I ordered the fan from Amazon. It was much cheaper than Summit. I will get
the fan back tomorrow from the machine shop.

I bought a pulley from Bob Woolridge. Everything is on my car except the
fan. Still running the stock one until the other one is ready.

She still seems to be a not so cool Cat. I have no idea where my kid put my
infrared thermometer. I know the gauge is off by 10 to 20 degrees. It stays
reading at 200 while cruising. Kinda scared to let her idle for too long.
She might cough up a hairball on the garage floor.

Chip