[Tigers] Electrical problem - ignition/ballast resistor?

[TtT]

Jay ...do a search on a toolset called CHAPMAN...it's tiny ratchet that uses screw drivers and allen wrenches about 3/4" long. I got mine from coal miners, as the set is sometimes the only tool a person can get into a tight place. I use stainless allen head bolts on my headers and torque them using my Chapman set. I have stripped one of the two ratcheys trying for extra torque but I knew better than using a cheater on them.Highly reccomend all Tiger owners buy a set!!!!
Sent from Huawei Mobile

Jay Laifman <jay.laifman at gmail.com> wrote:

>Seriously?
>
>I had my fingers in there with a very stubby phillips screwdriver and
>couldn't get leverage on the one screw I could get to. I gave up figuring
>if I couldn't do that one, the three inside were going to be impossible.
>
>I'm going to have to look again and see if I can get my allen key type
>phillips screw driver in there.
>
>Jay
>
>
>On Mon, Jun 3, 2013 at 12:49 PM, csx2282 <csx2282 at sonic.net> wrote:
>
>> I was able to fixed a leaky accelerator pump on my Holley by replacing the
>> diaphragm.  I didn't even have to remove the carb.
>>
>> Roland
>>
>> ------------------------------
>>
>>> From: Jay Laifman <jay.laifman at gmail.com>
>>>
>>> On the flip side, I noticed that the Holley is dripping gas out the
>>> bottom,
>>> from what looks like an accelerator pump.  Looks like the carb needs to
>>> come
>>> out to service it.
>_______________________________________________
>
>tigers at autox.team.net
>
>Donate: http://www.team.net/donate.html
>Archive: http://www.team.net/archive
>Forums: http://www.team.net/forums
>Unsubscribe: http://autox.team.net/mailman/options/tigers/achd73@yahoo.com