[Tigers] K&N Airfilter
genepadgett at comcast.net
genepadgett at comcast.net
Tue Apr 30 14:06:29 MDT 2013
Here is the link to the K&N site and the X-stream tab http://www.knfilters.com/universal/x-stream.htm
Looking at the installed height numbers, I think you will have a problem squeezing in one. I also have a LAT factory hood. With the stock filter and housing installed, I put lumps of modeling clay around the sides and front of the factory cleaner top. With a 1.5 inch high filter element, I did not find I had enough extra room. Depending on how high your manifold raises the carb, your results will vary from mine.
Keep in mind that unless you are running with the rear of the hood raised, you will need to allow some space for the air to get into the top element. How much to deduct for that is your call. I considered the dropped base option to see if I could make that work. Fort some reason I thought I would not be able to do that, but do not recall why.
What I ended up doing doing was making my on lid to use with the stock base and grafted on an 11 inch round X-stream top. When installed, I had about 1/2 inch clearance to the hood at the highest point. The 11 inch lid has an outer ring about 1 inch wide, so the air cleaner element itself is only about 9 inches in diameter. The center section for the hold down bolt is fairly large and also cuts down on the effective filter area. Just for cosmetics I did trim off the metal flange overhang at the front and back. You can do that without getting into the filtering element part.
I am currently looking into trimming off the part of the 11 inch lid that overlays the top of the standard filter element. I do end up cutting int the element to do that. I have a plan on how to reseal that cut into part. The goal is to get that to sit down inside the standard element to gain some vertical space for a taller standard element. Since the top 3/8 inch or so of the standard element does not flow air (due to sealing material) I am not really loosing any filtering element area on the standard element. That all is a WIP.
I do worry a bit about what would happen to my OEM fiberglass hood if I ever got a back fire through the top of the carb. I plan to some how epoxy on an aluminum plate over the top of the filter element in that area, just to be safe(r).
If you learn of a more elegant solution, please be sure to let all of us know.
Gene
PS: Regarding Theo's speculation about a 9 inch lid possibly working. I have looked at that one as well. Keep in mind that the 1 inch flange cuts the actual element area down to only a 7 inch diameter circle. The center hold down section is about a 2 or 2.5 inch diameter circle. Not a lot of element area left. Probably be better off just getting a 1/2 inch taller round element.
----- Original Message -----
From: "Brent Edinger" <banana111 at msn.com>
To: tigers at autox.team.net
Sent: Tuesday, April 30, 2013 12:54:21 PM
Subject: [Tigers] K&N Airfilter
Does any one have a part number for the K&N air filter with the flow though
top (X-Stream they call it)
that will fit the Tiger? I see it comes in all sorts of diameters and heights.
I'm running a performer 289
and Edelbrock carb and LAT hood.
Thanks, Brent
_______________________________________________
tigers at autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe: http://autox.team.net/mailman/options/tigers/genepadgett@comcast.net
More information about the Tigers
mailing list