[Tigers] Trunk seal install
Ron Fraser
rfraser at bluefrog.com
Sun Apr 28 11:57:07 MDT 2013
Mark
If the seal has a good deal of mould release on it; that should be
cleaned off.
I don't think you need to do much else. The seal just pushes onto the
trunk metal edge.
Find the middle of the seal; start that at the middle of the back edge of
the trunk and move around to the bottom of the trunk middle. The ends
should be glued to each other. You may have to cut the seal to fit.
I'm not sure that you need to glue the seal down but you might want to at
the ends.
Mine is just pushed on and only once in awhile do I need push one of the
ends back on.
Ron Fraser
-----Original Message-----
From: tigers-bounces at autox.team.net [mailto:tigers-bounces at autox.team.net]
On Behalf Of CoolVT at aol.com
Sent: Saturday, April 27, 2013 6:02 PM
To: tigers at autox.team.net
Subject: [Tigers] Trunk seal install
I have a trunk seal to install. I've had it hanging around for 10-15 yrs.
in a box. Still soft, but I'm sure natural aging has affected the
surface. The questions are: what should be done to prep the rubber? What
should
be done to prep the metal of the car? What is the best brand of adhesive
on the market?
Thanks,
Mark L
_______________________________________________
tigers at autox.team.net
Donate: http://www.team.net/donate.html
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe:
http://autox.team.net/mailman/options/tigers/rfraser@bluefrog.com
-----
No virus found in this message.
Checked by AVG - www.avg.com
Version: 2013.0.2904 / Virus Database: 3162/6275 - Release Date: 04/26/13
More information about the Tigers
mailing list