[Tigers] Tigers Digest, Vol 3, Issue 68

[Mark Rense]

George,
I just installed an engine/transmission this way and am sending you some
pictures. As you can see I used a lifting plate attached to the intake
manifold and a balance bar to keep the engine level. The front of the car
was raised to about a 45 degree angle and using a wheeled dolly for the
engine and a transmission dolly for the tranny I rolled the powertrain under
the car. I lowered the car over the engine, working the transmission tail
into the tunnel. 

The group cannot see these but anyone else let me know if you would like
these or have any questions.

Bugz


Date: Sat, 23 Jul 2011 23:34:55
From: George Re <mgman71 at comcast.net>
To: Tigers <tigers at autox.team.net>
Subject: [Tigers] Mounting points

Hello: I am about ready to install my engine (From under the car) and my
question is where are good mounting points to mount the engine harness on
the engine?. Thanks advance George Re. 

[demime 1.01d removed an attachment of type image/jpeg which had a name of Tiger991 Assembly13.JPG]

[demime 1.01d removed an attachment of type image/jpeg which had a name of Tiger991 Assembly6.JPG]

[demime 1.01d removed an attachment of type image/jpeg which had a name of Tiger991 Assembly7.JPG]

[demime 1.01d removed an attachment of type image/jpeg which had a name of Tiger991 Assembly9.JPG]