[Tigers] Plastic side moulding clips
e.coiner at cox.net
e.coiner at cox.net
Tue Aug 30 15:29:56 MDT 2011
I used a caliper to measure the diameter of the clip right under the flat part.
I drilled holes that were a couple of thousandths bigger. I do not remember the size drill I used.
I install the clip and push the pin in.
moulding will snap onto the clips, no need for sliding.
On each end of the moulding, I used a modified screw to secure it tightly.
I took a 4-40 button head cap screw. I filed two flats so that the head would slide down the moulding but not rotate.
---- Bob Dixon <bobdixon at frii.com> wrote:
> I was wondering if anyone had some tips on attaching the side moulding
> with those little plastic clips from Rick? I am assuming an 1/8" hole
> but that seems a little small. Do you put the clips on the body then
> slide the moulding on, or do you put the clips in the moulding and then
> tap the clips and moulding into place.
> _______________________________________________
>
> tigers at autox.team.net
>
> Donate: http://www.team.net/donate.html
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe: http://autox.team.net/mailman/options/tigers/e.coiner@cox.net
More information about the Tigers
mailing list