[Tigers] Tiger Pulley Part Number

[Theo Smit]

MAURO D'ANGELO wrote:
> All,  I need the part number of the Tiger pulleys, mainly the lower one by
> the balancer.  We're trying to figure out if the one we have is from a Tiger
> or some other car.  The part has a number C40E and under that is A1.  Does
> this sound like it is the right one?  Thanks.  Mauro
> _______________________________________________
> Support Team.Net  http://www.team.net/donate.html
>
> You are subscribed as tsmit at shaw.ca
>
> Tigers at autox.team.net
> http://autox.team.net/mailman/listinfo/tigers
>
> http://www.team.net/archive
>
>   
You'll know if it's right, by how close it comes to wiping out the 
steering rack tube.  It should only have one sheave, and about 1" offset 
from the balancer flange to the center of the sheave. Its outer diameter 
is about 5.5 or 6 inches. Most other Ford pulleys have a deeper offset 
and they won't leave enough clearance between the rack tube and the 
pulley. The correct one allows you to remove the water pump belt without 
having to crush it (too much) between the rack and the pulley.

Theo