[Tigers] Tigers Digest, Vol 4, Issue 11

[Smit, Theo]

If you do get oil lines made at a hydraulic shop, make sure they
understand that this is for a continuous-flow oiling system, not for a
hydraulic application. Hydraulic hose and fittings have smaller IDs than
oil hose, for the same hose OD and fitting thread sizes, and you'll get
much greater pressure loss in the lines.

Cheers,
Theo
> -----Original Message-----
> From: tigers-bounces at autox.team.net
> [mailto:tigers-bounces at autox.team.net] On Behalf Of BEAU2EVE at aol.com
> Sent: January 9, 2010 2:03 PM
> To: tigers at autox.team.net
> Subject: Re: [Tigers] Tigers Digest, Vol 4, Issue 11
>
> I put a remote oil filter under my left front fender, I used
> heater grommets to protect the line as it went through the
> inner fender. I used a high pressure line to reroute the oil
> lines there. Your local hydraulic shop should  have that.
> Since I have headers , I could not use the PH-8 filter either.
>
>
>
>                     Beau B9470951
> _______________________________________________
> Support Team.Net  http://www.team.net/donate.html
>
> You are subscribed as theo.smit at dynastream.com
>
> Tigers at autox.team.net
> http://autox.team.net/mailman/listinfo/tigers
>
> http://www.team.net/archive