[Tigers] Oil Pressure Part II

[e.coiner at cox.net]

That is a nice unit but it does not fit on my car with headers.

---- Steve Laifman <slaifman at socal.rr.com> wrote: 
> Ron and Eric,
> 
> I found a great alternative that is actually built by Ford MotorSport.  
> It was published on the TigersUnited.com site:
> 
> http://www.tigersunited.com/resources/Dealer_Accessories/mp-FilterAdapter2.asp    
> as co-edit by yours truly, Jim Boynton, and Mark L. (CoolVT)
> 
> The Ford MotorSport Filter is a very good one.  I would, as the article 
> states,
> 
>  This Ford MotorSport aluminum SVO right angle filter adapter, 
> M-6880-A50, is shown with the FRAM PH3600 in place. The Fram is smaller 
> in diameter than the FL1A, which does fit as well. The design is 
> different than the truck model, and has a large sealing surface on the 
> mounting nut, which is not removed for filter changing. I bought it at a 
> local Parts store for $50.  Well, make that $100, as the first one 
> bounced out of the trunk and I had to get another.
> 
> While this may be difficult to obtain now, it is worth it.  Notice that 
> the edge car motor mount (on the left side of the car), was slightly 
> rounded to prevent contact.
> 
> There is a Ford Truck mount, which may be available, but isn't as nice.
> 
> Steve
> 
> <http://www.tigersunited.com/resources/Dealer_Accessories/mp-FilterAdapter3.asp,,p.p1%20%7Bmargin:%200.0px%200.0px%200.0px%200.0px;%20font:%2012.0px%20Helvetica%7D,,Steve%20Laifman> 
> 
> 
> Steve Laifman 
> <http://www.tigersunited.com/resources/Dealer_Accessories/mp-FilterAdapter3.asp,,p.p1%20%7Bmargin:%200.0px%200.0px%200.0px%200.0px;%20font:%2012.0px%20Helvetica%7D,,Steve%20Laifman>
> 
> Editor
> 
> http://TigersUnited.com