[Tigers] direction of oil flow through filter

[Smit, Theo]

On the filter, there's a one-way valve that allows the oil only in
through the outside, and out through the center.
Most of the cast remote mounts have enough of the oil passages evident
that you can tell which ports run to the center of the filter base and
which run to the outside. Sometimes you can just go by which ports are
closer to the central axis of the base. Some of the mounts have the
ports labeled IN and OUT... You might need a good light and a brush to
remove road grime.

Cheers,
Theo

> -----Original Message-----
> From: tigers-bounces at autox.team.net
> [mailto:tigers-bounces at autox.team.net] On Behalf Of Owain Lloyd
> Sent: December 15, 2009 11:14 AM
> To: tigers at autox.team.net
> Subject: [Tigers] direction of oil flow through filter
>
> hello,
>
> i have a remove filter in the wheel arch plumbed into a 4
> port sandwich plate.  i would like to install an oil cooler,
> thermostat and check valve inline after the filter.
>
> any clever ideas for the easiest and least messiest way to
> tell which hose runs to the filter and which back to the block?
>
> thanks,
>
> - owain.
> _______________________________________________
> Support Team.Net  http://www.team.net/donate.html
>
> You are subscribed as theo.smit at dynastream.com
>
> Tigers at autox.team.net
> http://autox.team.net/mailman/listinfo/tigers
>
> http://www.team.net/archive