[Tigers] Water pump flange height

[Ronak, TP (Timothy)]

Listers,

Can anyone confirm the stock pulley flange distance for a 260 Tiger.
Based on my research it should be 4.875 inches from the back of the pump
bolt on flange to the outer face of the pulley flange. I realize this is
different than the shop manual. I am going to go press two pumps but do
not have a pump to go off of that is off of the car. (never thought to
save one) if anyone can confirm this before I go jack up two Edelbrock
pumps I would be VERY grateful.



Best Regards,

Tim Ronak
Services Consultant

Akzo Nobel Coatings
23961 Via El Rocio
Mission Viejo, CA 92691

Bus: 949-305-5393
Fax: 425-955-6268
Cell: 949-289-3357
email: timothy.ronak at crna.akzonobel.com
Personal email: timronak at cox.net