[Tigers] Show Bar

[Thomas Witt]

Using PVC tubing can be an economical way of mocking up a bar. While using 
the appropriate diameter would be idea, even that can start to cost. So, for 
a few bucks using say..., 3/4" you can still "rough in" what you need.  Just 
make sure that any measurements are specifically demoted to the larger 
outside perimeter. The fabricator can figure the inside bends.
  Having read Theo's comments I am wondering if the bar could be bent with, 
for lack of a better term, a "wave" near the drivers head that went rearward 
to allow better clearance for a helmet?
Tom