[Tigers] Throttle Body Under AC Filter Cover FYI

[Theo Smit]

Frank,
I started down this route with a used old-school analog Pro-Jection (the 
two-barrel style). I built a 1/2" tall adapter plate to go from the 
spreadbore pattern to the square bore pattern, and a couple of adapters 
to go from the fuel fittings used on the throttle body to -6AN. I got 
the correct fuel pump to go with this as well as an oxygen sensor and 
the closed-loop kit.
This is all back in '02 or so... then I got busy with a lot of other 
stuff and the Pro-Jection sat. When I had the transmission and engine 
out of the Tiger I ran new fuel line and a return line in the tunnel, 
but that's about all I did so far as fuel injection related stuff is 
concerned.

Then when the Retrotek BossEFI was announced last summer (and I was 
still slowly working towards getting the Tiger back together) I decided 
that I'd rather go that route. I currently have the throttle body 
sitting on the F4B manifold, I'm using the fuel line I'd routed earlier 
as the return line, the fuel line is going to be re-done, and I'm busy 
mounting filters and the fuel pump in the spare tire well.

So I'm going to be left with a used, but never used by me, analog 
two-barrel Pro-Jection, along with its controller and closed-loop 
controller, water temp sensor, and wiring harness; and brand-new fuel 
pump and O2 sensor to suit this system, as well as a handmade low-rise 
adapter (basically a new bottom plate) for the throttle body. If you 
want/need any part of this let me know.

Cheers,
Theo



fsimer at gac.edu wrote:
> I will be adding a closed loop TB FI  system (Holley pro-jection with  
> and added sensor and controller) on my Tiger probably in April/May, if  
> anyone has done it...let me know how it went.