[Tigers] Miloden Water Pumps

[Dave Munroe]

Hey guys: (any "gal"  listers out there?)

Does anyone know if its possible to press the shaft back in a Miloden water 
pump to gain clearance from the rad?

Since I installed an alloy rad approx  3/4 inch thicker than stock, and 
fitted the original shroud, the fan blades are now buried
in the shroud completely. I understand for maximum effect the blades should 
be roughly 2/3 inside - 1/3 outside the shroud.
Two possible solutions: fit a shorter water pump (does one exist?) or 
shorten the shroud, which would reduce the shroud's
effectiveness.

I'm not sure which is the better of two bad choices: leave the fan buried ot 
cut down the depth of the shroud?

Any suggestions?

Cheers,

Dave Munroe