[Tigers] Fulcrum pin bolts
DJoh797014 at aol.com
DJoh797014 at aol.com
Fri Apr 11 16:44:32 MDT 2008
The usual cause of stripping the bolt is what I've advised about before.
three of the 4 crossmember bolts usually go in OK but the 4th is
just off enough to not go or strip when it goes in at a slight angle.
The three bolts that go in should not be snugged down to allow
for movement.
The weight of the engine spreads the frame rail. Put a 2x6 or
such under the oil and jack slightly to lift the engine a little.
Now the bolt will go in correctly With a light you can actually
watch the bolt and hole line up.. Don't crush your oil pan.
The bolts are grade 8 NF available from you local CAT or Deere
dealer. Don't use a cheap bolt.
Once all 4 are in then torque to specs.
Dave
In a message dated 4/11/2008 1:27:40 P.M. Central Daylight Time,
brockctella at juno.com writes:
I found one of the 3 inch bolts that secure the front suspension
stripped. My first thought is to find a new one and see if the bolt is
the problem. If not do I retap the outer welded nut? Is there more inside
that you can't get to(the suspension arm is sealed).? Thanks for any
advice.
You are subscribed as djoh797014 at aol.com
Tigers at autox.team.net
http://autox.team.net/mailman/listinfo/tigers
http://www.team.net/archive
**************It's Tax Time! Get tips, forms and advice on AOL Money &
Finance. (http://money.aol.com/tax?NCID=aolcmp00300000002850)
More information about the Tigers
mailing list