[Tigers] oil filter adapter

[Stu Brennan]

It did not appear that there was room to angle the adapter forward.
Folks on this network have been using these adapters for years, so if
any direction other than the standard one would work, I'm sure someone
would have mentioned this. 

I'm using a Fram PH3600/Ford FL400 size filter.  Smaller diameter, but
about the same length as the FL1.  Diameter is the issue with clearance
to the motor mount.  If I got out my angle grinder and took just a bit
off of the motor mount, I could use the FL1/PH8A size filter, same as
the original.

The PH3600 has then same thread, gasket, pressure release, burst
pressure, etc., as the PH8A.

Stu