<div dir="ltr">Only a fool uses an angle grinder without a guard and yesterday I was that fool.<br>While I have several angle grinders, I need one more before I no longer have to change the occasional disc from one type to another.  The usual dilemma is which grinder to change the disc on so that half an hour later I’m not changing it back again.  I’d had a fairly well used hard disc on one grinder and had removed the guard to get into a tight spot while working on the Sprite’s floor pan replacement.  I was now replacing the garage roof and needed a thin cutting disc to cut through some old J bolts and other fixings and fitted a full-size brand-new thin cutting disc. It wasn’t long before I cut through my glove and into my finger.  The cut isn’t very deep and I guess the gloves helped.  Of course, I didn’t immediately put the guard back on it and had to have a near miss before I did.  I realised at that point it might not have had the accident if I’d used a smaller disc.  So, I’m sharing my stupidity in the hope others won’t be the fool, albeit a ‘lucky’ fool that I was yesterday and use a angle grinder without the guard.<br><div><br></div><div>Daniel the sometime fool</div></div>