<div dir="ltr"><div>     I acquired a set of forged rockers and a hardened rocker shaft from David Anton to "build" a new rocker arm assembly.  This is for the new engine I am building to replace the rod knocking 1275 in my Bugeye.  For what it costs, I am committed to put this assembly together.  The one caveat that David told me when he sold me the set of shaft and rockers was that the rocker bushes had to be honed to fit the shaft.  The hardening process had increased the diameter of the shaft by a couple of thousands.  Not a problem.  I found a local shop that can do it.  The rockers should have a clearance of 1 -2 thou for proper lubrication.  The one thing I did not take into account was the pillars.  Should they be honed also?  I can find no indication anywhere of the clearance dimension for the shaft to pillar fit. Knowing that a tight fit will produce failure and too loose of a fit will drop oil pressure.  A question for you engine builders out there.</div><div>Mike MacLean  <br></div></div>