<div dir="ltr">Hi List,<div><br></div><div>Well I thought I learned how to tap a thread at school in 'Metalwork' lessons (passed with CSE grade 1) but rarely cut a thread/tap a thread these days.  I think the last ones I did was when I was making handbrake rods for my Sprite using Stainless Steel (and had a lot of help from a friend with a lathe for some of the parts).</div><div><br></div><div>Anyway Youtube managed to suggest this clip for me and I found it interesting.  I haven't finished it yet (or ripped a copy . . .) but wanted to paste a copy here.  I'm up to the part where thread go/no go gauges are used.  Now while I know what a go/no-go gauge is (used in some eligibility checking in motorsports scrutineering) I never knew there were specific thread go/no-go gauges and since I found some on ebay I might get a couple.  That way even if I never use them, one day when I am dead and buried and someone is checking out my tool kit they'll think I really knew my stuff!</div><div><br></div><div><a href="https://www.youtube.com/watch?v=33wfSMsUbuc">https://www.youtube.com/watch?v=33wfSMsUbuc</a><br></div><div><br></div><div>Regards</div><div><br></div><div><br></div><div>Daniel</div></div>