<div dir="ltr">Hi List,<div><br><div><div>I've just finished making my first mirror bracket.  Well actually it's the second because I abandoned the first one part finished as it wasn't quite right.  I'm pleased with the end result but I'll be making another one as this one isn't quite perfect.  Yep, it does stick out a bit from the bodywork (just under 3 inches) but its supposed to because being close to the car's bodywork makes it much less aerodynamic (air sees a bigger bulge than the actual mirror).  Very wet here so it may be a week before it gets road tested - the worst that can happen is that it vibrates and I need to use thicker aluminum sheet (this was 1.2mm) or stainless steel sheet.</div><div><br></div><div>Photos attached.</div><div><br></div><div>Regards</div></div><div><br></div></div></div>