<div dir="ltr">Gary,<div><br></div><div>Here is something I wrote back in 2012...... It still applies ;)</div><div><br></div><div><br><div class="gmail_quote">---------- Forwarded message ----------<br>From: <b class="gmail_sendername">Kevin Valentine</b> <span dir="ltr"><<a href="mailto:kevinv1275@gmail.com">kevinv1275@gmail.com</a>></span><br>Date: Sun, Jun 24, 2012 at 11:17 PM<br>Subject: Observations on Troubleshooting On the Road<br><br><br><br>Hey ALL,<div><br></div><div>I have recently had several occasions (three phone call in the past 5 days) where it was necessary to troubleshoot problems with Spridgets which had stopped running abruptly at very inconvenient times. The following checklist may come in handy for those of you who may find yourself in this situation and don't mind trouble shooting things yourself.</div>
<div><br></div><div>Given that the mechanicals of your engine are working properly, you need three things to keep the internal combustion engine running. Fuel Air, and Spark.</div><div><br></div><div>In most cases Air is not the problem, unless you have let your air cleaners get so dirty that no air can pass thru them or there is some foreign object sucked into your air cleaner(s). </div>
<div><br></div><div>If you find yourself at the side of the road, here are a few things you can check;</div><div><br></div><div><font color="#FF0000">The disclaimer is; If you don't feel comfortable performing any of the following checks, use your cell phone and either call AAA or call someone to come and help you.</font></div>
<div><br></div><div>I always do checks for spark BEFORE I do the checks for Fuel delivery. You don't want any stray fuel vapors anywhere near an area where you will be creating a spark.</div><div><br></div><div>Note; More than once, I have witnessed an A-series distributor that has dislodged itself from the hole in the engine block due to a distributor clamp that was not tightened properly. Checking to make sure the distributor is held securely in the clamp would be well advised before you check for other electrical problems.</div>
<div><br></div><div>Another important note; Before you check electrical connections under the bonnet of you car, <font color="#FF0000">MAKE CERTAIN YOU HAVE NO FUEL LEAKS</font>.</div><div><br></div>
<div>To check for spark. First check for spark at the points. Remove the distributor cap and watch the points while you turn the engine over with the starter. Make certain the ignition is switched on if you have a separate switch for the ignition on your car. If you can not see the points while you are turning the engine over with the starter (you are by yourself and have no one to help you), switch on the ignition and flick the points with a small screwdriver (or your finger) to see if you get a spark when the points are separated. If you have no spark at the points, check for loose wires to the coil and/or distributor. The problem may be in the electrical wiring at your ignition switch. You can hot-wire the coil with a short piece of wire. (I carry a jump wire with alligator clips on each end). On a negative ground car, connect the jump wire to the positive side of the coil and to the positive post on the battery and check for spark at the points again. If you still have no spark at the points, the problem may either be the condenser or the coil.</div>
<div><br></div><div>If you have spark at the points, - next check for spark at one of the spark plugs. The easiest way to do this is to remove one of the spark plugs and with the ignition wire for that spark plug wire attached to the plug, hold the spark plug in contact with the engine and turn the engine with the starter. You should see a spark at the gap in the spark plug. If you have spark at the points but no spark at the plug you may have a faulty distributor cap or rotor. If you have a spark at the spark plug, it's time to check for fuel supply. Put the distributor cap back on and re-install the spark plug. You don't want any stray sparks while you are checking for fuel supply.</div>
<div><br></div><div>To check for fuel delivery. Disconnect the fuel line at the carburetor and activate the fuel pump. (On cars with electric pumps, turning on the ignition will accomplish this. On cars with mechanical fuel pumps you will need to turn the engine with the starter). If you have no fuel being delivered at the fuel line you disconnected from the carb, you may either be; out of fuel, your fuel pump stopped working, or you have a blockage in the tank or at the fuel filter. Another possibility is a broken fuel line between the tank and the engine.</div>
<div><br></div><div>I hope you never need to do any of the trouble shooting mentioned above, but if you do, I hope this helps.</div><span class="HOEnZb"><font color="#888888"><div><br></div><div>Kevin</div><div><br></div><div><br></div><div><br></div><div><br></div>
<div><br></div><div><br></div><div><br></div>
</font></span></div><br></div></div>