[Spridgets] Question about mating the transmission to the engine
rrengineer.mike
rrengineer.mike at att.net
Tue May 17 05:47:29 MDT 2016
U have had the same thing happen. Just try a little harder. Sometimes it "pops" into the pilot bushing. There is not much space for the air to get out you are displacing with the shaft.Mike MacLean
Sent via the Samsung GALAXY S® 5, an AT&T 4G LTE smartphone
-------- Original message --------
From: David Ambrose via Spridgets <spridgets at autox.team.net>
Date: 5/16/2016 10:03 PM (GMT-08:00)
To: Spridgets at autox.team.net
Subject: [Spridgets] Question about mating the transmission to the engine
We're trying to mate a new transmission to a 1275 engine. After a two
attempts at assembling the clutch using the clutch pilot, we were able
to mostly mate the transmission to the engine. There's about 3/8 inch
left. The transmission isn't going on easily and I'm wondering if we
should use the bell housing bolts to pull them together or take is all
apart again, and make another try.
This is a replacement transmission of unknown parentage other than it
came out of a Midget. I was wondering if the pilot bushing might be a
different diameter. Were there multiple sizes?
Thanks,
Dave Ambrose
------------------------
spridgets at autox.team.net
Donate: http://www.team.net/donate.html
Suggested annual donation: $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: http://autox.team.net/mailman/options/spridgets/rrengineer.mike@att.net
-------------- next part --------------
An HTML attachment was scrubbed...
URL: <http://autox.team.net/pipermail/spridgets/attachments/20160517/5c9f2b5a/attachment.html>
More information about the Spridgets
mailing list