[Spridgets] Front wheel bearings

[WeslakeMonza1330 at aol.com]

I think it was more like a massive washer that would have been required and 
 even them I wasn't confident that was the way to go so earlier this 
morning I  bought the expensive bearings.
 
 
In a message dated 26/03/2012 04:58:44 GMT Daylight Time,  
dlh2001 at comcast.net writes:

The  bearings are fine. You need a strategically placed shim.
Study the  picture's on Norm's page. It should become clear
where the shim has to go  to take up the play that tightening 
the spindle nut does not.  

Bigger problem...where to get the shim?