[Spridgets] FW: Water Temp Gauge Problem
Dean Swanson
d.swanson at earthlink.net
Thu Jul 12 20:20:56 MDT 2012
Kirk,
A friend/co-worker of mine found instructions online of how to take the
bulb/tube off a new cheap gauge and fix the old gauge.
http://www.ply33.com/Repair/tempgauge
I can check at work tomorrow and see if he did anything else special...
-----Original Message-----
Sent: Thursday, July 12, 2012 1:47 PM
To: Spridgets
Subject: [Spridgets] Water Temp Gauge Problem
My original water temp included within the oil pressure gauge stopped
working. For a temporary fix I installed an under dash water temp unit
from the auto parts store.
I was able to make the unit fit my head without damaging the threads . .
and it is reading in accordance with my thermostat when the thermostat
opens up . . if nothing else it might serve as a warning if my temp gets
too high. (The included adapters did not fit of course and the adapters
are typically necessary as they form the seal).
Does anyone have a good reference on who rebuilds gauges and what it might
cost to have this done so that I can go back to the original set up?
I wish there was a way I could buy a new line to the original temp gauge as
I think the problem is with the sender line when I pulled my engine the
last time around. The internal wire on the original unit is ok. . but I
noticed a spot where the surrounding coiled wire was broken . . and I am
not sure if this break would cause the problem.
Any input is certainly appreciated.
Thanks . . .
Kirk
1275 59
------------------------
More information about the Spridgets
mailing list