[Spridgets] Rebuilding master cylinder

[an5.sprite at gmail.com]

I was faced with the same question a few years ago. my brake and clutch worked but I decided to rebuild them. Once I took them apart I could see the bores where clean so just rebuilt them. Getting the inner clip off the master can be a bit tough. Also I took a picture of the piston after I removed it to help in the reassembly. Two years later (with Dot 5) all works well.

However, I saw some a bit of rust in the clutch slave and just tossed it.

Steve
------Original Message------
From: jwagaman1 at comcast.net
Sender: spridgets-bounces at autox.team.net
To: spridgets
Subject: [Spridgets] Rebuilding master cylinder
Sent: Nov 22, 2011 9:01 AM

Any advice on rebuilding my 74 brake master cylinder?

Better to rebuild or buy new one from Moss/VB for about $150?

I am planning on just replacing rubber? Is this easy to remove from car?

Thanks again for all your advice!!!!

Jeff
_______________________________________________

Donate: http://www.team.net/donate.html
Suggested annual donation  $12.75
Archive: http://www.team.net/archive
Forums: http://www.team.net/forums
Unsubscribe/Manage: http://autox.team.net/mailman/options/spridgets/an5.sprite@gmail.com



Sent from me.