[Spridgets] (no subject)

Guy R Day grday at btinternet.com
Tue Aug 16 09:54:13 MDT 2011


After 5 sets of drilling the bit was blunt?


----- Original Message ----- 
From: "Kevin Valentine" <>
To: "John Deikis" <>
Cc: <spridgets at autox.team.net>
Sent: Tuesday, August 16, 2011 3:49 PM
Subject: Re: [Spridgets] (no subject)


> John,
> 
> Third party/aftermarket hardening?
> 
> Kevin V.
> Tuscarora, Pa
> 
> 
> 
> On Aug 16, 2011, at 10:35 AM, John Deikis wrote:
> 
>> I just drilled out a box of spare axels to accommodate 7/16-inch  
>> studs. All
>> had the same numbers and the same "late axel" groove machined  
>> around the
>> spline end. But one of them was incredibly harder to drill out. In  
>> fact, it
>> was impossible with my regular bits, while the other 5 went like  
>> butter.
>> Obviously, some runs of "identical" axels had flanges, at least,  
>> that were a
>> lot harder then the norm.
>>
>> Anyone else come across this...or have an explanation?
> _______________________________________________


More information about the Spridgets mailing list