[Spridgets] FW: fuel delivery issue
banjojohn at cox.net
banjojohn at cox.net
Mon May 10 13:19:27 MDT 2010
Good thought.
---- Larry Daniels <ladaniels at sbcglobal.net> wrote:
> John, you probably will want a filter before the fuel pump, as well.
>
> LAD
>
> --------------------------------------------------
> From: "John O'Brien" <banjojohn at cox.net>
> Sent: Sunday, May 09, 2010 10:31 PM
> To: "'Spridgets'" <spridgets at autox.team.net>
> Subject: [Spridgets] FW: fuel delivery issue
>
> Thanks for everyone's responses a few weeks ago. I believe I finally found
> and fixed the culprit. I pulled the fuel tank today and removed the sender.
> I could see that the previous owner had done a coating treatment to the
> tank. I have had the car about 15 years and did not realize it. It looks
> like the coating was applied by sloshing it around in the tank, and it
> coated the screen filter for the pick up tube. It must have had enough
> leakage that it could supply enough fuel until I ran it hard and then it
> just ran out of gas it could get through the mostly clogged screen. It has
> probably had the few holes in the coating gradually fill with particles over
> the years till it could not get enough fuel through. My solution was to
> take a long screw driver and punch through the screen in several places. I
> am using an inline fuel filter, so I should catch any debris before it gets
> to the carbs. I took it for a spin tonight, and so far so good. After
> seeing the coated screen, about 2/3 of the way up, I am surprised I could
> get enough fuel to run at all, once the fuel level got below the coated
> area. Anyway, I thought I'd report back incase someone else has a similar
> issue,
>
> Thanks
>
> John O'Brien
>
> '61 bugeye
>
> '65 BJ8
>
>
>
> _____
>
> From: John O'Brien [mailto:banjojohn at cox.net]
> Sent: Wednesday, April 14, 2010 9:41 PM
> To: 'spridgets at autox.team.net'
> Subject: fuel delivery issue
>
>
>
> Hi all you wealth of knowledge:
>
> My Bugeye with a 1275 has been giving me a challenge lately. Last year it
> would die suddenly after driving for a while, and usually after sitting at
> idle for a while and then pushing it hard. I would sit for 5 minutes and
> then it would start and run normally again. It seems like it started after
> I dropped the fuel tank to reseal the sender unit. I had been having gas
> leak around the sender if I filled the tank full. I thought I had a non
> vented gas cap, so I bought a new one. Still happening even if I leave the
> cap off or loose. I have an aftermarket Mr. Gasket electronic fuel pump
> mounted just above the fuel tank in the axle tunnel. I thought it might be
> acting up, so I put in another one I had and got the same result. I have a
> glass fuel filter in the engine bay, and I can see that when I first start
> and until it gets hot the filter is full of gas. When it starts acting up,
> I can see that the filter is empty. I thought about vapor lock from heat in
> the engine bay, so I insulated the fuel line from where it comes up from
> under the car to nearly the carburetors, leaving the filter uncovered so I
> can see. It is still happening. Does anyone have any idea what is going
> on, and what I can do to stop it? I used to have the fuel pump in the
> engine bay instead of near the tank. I thought having the fuel line
> pressurized from the tank forward would decrease the likelihood of vapor
> lock. I don't remember having trouble with vapor lock when the pump was in
> the engine bay.
>
> Thanks for any help.
>
> John O'Brien
>
> '61 bugeye
>
> '65 BJ8
> _______________________________________________
>
> Donate: http://www.team.net/donate.html
> Suggested annual donation $12.75
> Archive: http://www.team.net/archive
> Forums: http://www.team.net/forums
> Unsubscribe/Manage:
> http://autox.team.net/mailman/options/spridgets/ladaniels@sbcglobal.net
More information about the Spridgets
mailing list