[Spridgets] wire wheel rear end conversion
WeslakeMonza1330 at aol.com
WeslakeMonza1330 at aol.com
Tue Jan 26 10:50:28 MST 2010
Quaife will do them.
In a message dated 26/01/2010 02:49:22 GMT Standard Time,
dlh2001 at comcast.net writes:
It would be nice if someone would offer aftermarket 1/2" longer axle
shafts in 4340 steel.
The raw material is about $90. It would need to be machined the whole
length and splined at each end.
If you know a good machinist then I think this might be the best way to
go, but I've never met anyone
who did it this way.
More information about the Spridgets
mailing list