[Spridgets] Rivergate 5-speed

[Edward Perez]

Same here.  Datsun clutch and pressure plate.  The pressure plate needs to be drilled for the alignment pins on the flywheel if you have them.

 Edward Perez
Snohomish, WA
78 Midget (1275)
http://www.flickr.com/photos/lbc_newbie/




________________________________
From: David Ramsey <dwramsey at att.net>
To: Michael Rowe <mdrowe at optonline.net>
Cc: spridgets at autox.team.net
Sent: Fri, February 12, 2010 7:22:49 PM
Subject: Re: [Spridgets] Rivergate 5-speed

I used a Datsun clutch.
        Crash


Those of you with Rivergate conversion kits:

How did you remove the contact plate from the fingers of the clutch pressure
plate as required to use a roller-type throw-out bearing?  

Michael Rowe
Aspiring engine builder
Suggested annual donation $12.75

You are subscribed as eap2140 at yahoo.com

http://www.team.net/archive

http://autox.team.net/mailman/listinfo/spridgets